Expand your EW-IEM system with a separate EW-IEM EK. Multiple receivers on one transmitter can obviously be very useful when talking about in-ear monitoring. Not only can you always use an extra bodypack as a backup in case something goes wrong, but of course it is also possible to connect multiple receivers to one transmitter.
In-ear monitoring can be quite an expensive proposition if you want to do it right. Never mind that of course every transmitter has to receive a signal and the AUX outputs on many mixers are limited. Here it could possibly be smart to put multiple receivers on one transmitter. With one EW-IEM transmitter, you can send either one stereo mix or two mono mixes to as many receivers as you want. A very practical solution in a situation where you can only do one or two AUX mixes, or a budget-friendly solution for the band.
Read more
- Rugged bodypack receiver delivers clarity across the frequency spectrum for everyday use on stage
- Easy and flexible wireless synchronization between transmitter and receiver via infrared
- Compatible with Sennheiser WSM control software for flexible frequency assignment
- Up to 16 compatible channels
- Up to 42 MHz bandwidth with 1680 selectable frequencies, fully tunable in a stable UHF range
- Transmission range: up to 100 meters (clear view)
- High RF output power (up to 50 mW) depending on national regulations
Specifications:
- Blocking ≥ 80 dB
- Receiver principle Adaptive diversity
- Temperature range -10 °C to +55 °C
- Bass Boost +8 dB at 8 kHz
- Squelch 5 to 25 dBµV, adjustable in 2 dB steps
- RF sensitivity < 4 μV, typ. 1.6 μV for 52 dBA rms S/N
- Reception frequency Max. 1680 frequencies, adjustable in 25 kHz steps, 20 frequency banks, each with up to 16 preset
- preset channels, no intermodulation, 6 frequency banks with up to 16 programmable channels
- Power supply 3 V battery / 2.4 V rechargeable battery
- Limiter -18 dB to -6 dB, adjustable in 6 dB increments, disable
- Intermodulation attenuation Normal ≥ 70 dB
- Audio output power 2 x 100 mW at 32 Ω
- Rejection of adjacent channels Typically ≥ 65 dB
- with the transmitter switched off: ≤ 25 µA
- Current consumption at rated voltage: approx. 140 mA
- Power supply 2 AA batteries, 1.5 V or BA 2015 battery pack
- Modulation Broadband FM
- Operating time approx. 4 to 6 hours (depending on volume level)
- Nominal deviation ±24 kHz
- Peak deviation ±48 kHz
- Switching bandwidth up to 42 MHz
- Signal-to-noise ratio approx. 90 dBA
- Weight (incl. batteries) approx. 125 g
- THD, total harmonic distortion ≤ 0.9%
- Comparator Sennheiser HDX
- Dimensions approx. 82 x 64 x 24 mm
